Ryan,
Sounds like a simple configuration settings issue.
I would follow the directions provided by the folks that you bought the RIM-Alinco from.
If they did not provide directions I would contact them directly.
I am sure that they have a basic configuration setting instructions for their RIM-Alinco to get you up and running easily.
73
Marshall - ke6pcv
···
From: Ryan Hartnett via AllStarLink Discussion Groups [mailto:noreply@community.allstarlink.org]
Sent: Saturday, March 21, 2020 10:24 AM
To: ke6pcv@cal-net.org
Subject: [AllStarLink Discussion Groups] [App_rpt-users] Troubleshooting Help
KF8IV
March 21
Hello,
I am new to Allstar so please be gentle.
I have setup my Allstar node with a raspberry pi 3, Alinco D135 and the RIM-Alinco interface. The node is recognized online through Allstarlink. I have Echolink up and running without a problem.
The issue is this: my DTMF codes dont work when I key the radio with my HT. When I have someone connect to my node, he says its all static. When I run the simpleusb-tune menu, I go to the visual graph with rx. When I key my HT, the graph disappears, sound comes through the radio and then when I release the PTT the graph reappears again.
Any help would be appreciated. I think I have this about 99% setup correctly?
Thanks!
Ryan, KF8IV
Visit Topic or reply to this email to respond.
You are receiving this because you enabled mailing list mode.
To unsubscribe from these emails, click here.