I am attempting to get carrier squelch mode to work. The relevant parts of my usbradio.conf are shown below. Even with this configuration the repeater is always in P/L decode mode. I know for sure there is not a P/L decoder in the repeater. Any ideas?
txctcssdefault=100.0 ; default tx ctcss freq, any frequency permitted
rxctcssfreqs=100.0 ; rx ctcss freqs in floating point. must be in table
txctcssfreqs=100.0 ; tx ctcss freqs, any frequency permitted
carrierfrom=usb ; no,usb,usbinvert,dsp,vox
ctcssfrom=no ; no,usb,dsp
rxdemod=speaker ; input type from radio: no,speaker,flat
I am attempting to get carrier squelch mode to work. The relevant
parts of my usbradio.conf are shown below. Even with this
configuration the repeater is always in P/L decode mode. I know for
sure there is not a P/L decoder in the repeater. Any ideas?
txctcssdefault=100.0 ; default tx ctcss freq, any frequency permitted
rxctcssfreqs=100.0 ; rx ctcss freqs in floating point. must be in
table
txctcssfreqs=100.0 ; tx ctcss freqs, any frequency permitted
carrierfrom=usb ; no,usb,usbinvert,dsp,vox
ctcssfrom=no ; no,usb,dsp
rxdemod=speaker ; input type from radio: no,speaker,flat