Johnny,
Check your simpleusb.conf and make sure of the following settings.
Carrierfrom=usb
Ctcssfrom=**no **
73
Marshall
···
From: Johnny Twist via AllStarLink Discussion Groups [mailto:noreply@community.allstarlink.org]
Sent: Friday, April 03, 2020 7:38 AM
To: ke6pcv@cal-net.org
Subject: [AllStarLink Discussion Groups] [App_rpt-users] New User - Stuck at Zero Receive Level
Johnny_Twist
April 3
Greetings all,
New user here… here’s my setup - Kenwood TM-V71A - URIxB - RPi3.
I can get my radio to key up and play the tones using the simplusb.conf file menu, but i’m not showing any receive audio on the RX adjust.
I’ve made sure to comment in the ‘load simplusb.conf’, radio is set to 1200bps & on VFO A. Just stuck at this point.
Any ideas? Thanks!
Visit Topic or reply to this email to respond.
You are receiving this because you enabled mailing list mode.
To unsubscribe from these emails, click here.