HTTP Not registered

AllStarLink
1

Hello; My setup saga continues As mentioned before am switching over to ASL3. Up to this point all seems to be working with the exception of the URI Interface config and NOW http not register on the system. I've check port setting i.e. 4569 being port forwarded on my router. Obviously the Allmon3 will not connect either.
I'm missing a step in the installation. Any Help would be GREATLY appreciated.

WA7BFN/45684

Package Version

============================== ==============================
allmon3 1.8.1-1.deb13
asl3 3.18.2-2.deb13
asl3-appliance 2.1.0-2.deb13
asl3-appliance-pi 2.1.0-2.deb13
asl3-asterisk 2:22.9.0+asl3-3.9.3-1.deb13
asl3-asterisk-config 2:22.9.0+asl3-3.9.3-1.deb13
asl3-asterisk-modules 2:22.9.0+asl3-3.9.3-1.deb13
asl3-menu 1.18-1.deb13
asl3-update-nodelist 2.0.0-1.deb13
asl-apt-repos 2.0-1.deb13
cockpit 337-1+deb13u1
cockpit-bridge 337-1+deb13u1
cockpit-networkmanager 337-1+deb13u1
cockpit-packagekit 337-1+deb13u1
cockpit-sosreport 337-1+deb13u1
cockpit-storaged 337-1+deb13u1

cockpit-system 337-1+deb13u1

cockpit-wifimanager 1.2.0-1.deb13
cockpit-ws 337-1+deb13u1
dahdi 1:3.1.0-2.1
dahdi-linux 1:3.4.0-11.asl.deb13

2

All three things are likely unrelated. If you are "upgrading", confirm you didn't just copy in old configuration as they will not work. Make sure you use asl-menu to setup clean. Also run asl-node-auth-check to test your configuration for authentication issues.

3

Hello; This is a new installation. using my old number should I define a new node number?

4

No need for a new node number.

5

Testing node 456841:
OK: Node registration config is well-formed
OK: Node registration type is HTTP
OK: register.allstarlink.org is reachable (via HTTP)
Error: HTTP registration state is Not Registered
Info: Stopping node checks due to registration failure
Info: as further information will be unreliable

At a dead end as to why we can't get the node registered on Allstarlink.org. I've reinstalled a new img again with same results. I've double checked my port forward 4569 , and created an updated node number. 456841 which appears to be "on line" on the node page

Any ideas would be really appreciated, before I sling shot this thing to the river hi h i.

WA7BFN / 456841

6

Did you use the Raspberry Pi Imager or did you install Linux and then install ASL 3 with the Appliance package?

KE2HNI

7

I used the RPi imager and followed very closely on its setup

8

If your config is sane (which is checked by asl-node-auth-check) then it's a password problem.

9

OK Password... as to which.. Allstrlink? the pi the node . and where do check that? thanks

10

asl-menu -> Node Settings -> AllStar Node Setup Menu -> Update Node NNNNN -> Node Password. Then restart asterisk in the menu when prompted. Also:

11

Thanks that was it Cheers