Hello All,
I am wanting to configure my node to have two PL tones where when one is used for local communications and the other goes out the link. I know some people were able to get it working and I was wondering if I can get some help. I remember that I could add the other PL tones separated by a comma. >From what I understood, the first PL will send the audio out the link and the remaining PLs will be local.
My Config:
–running DIAL on a small form factor pc.
----using USBRadio
----DSP carrier and PL decode
–Repeater is a Kenwood TKR-850 and configured with an open squelch to AllStar, no PL decode or encode.
In my usbradio.conf
txctcssdefault=100.0
rxctcssfreqs=100.0,88.5
txctcssfreqs=100.0,88.5
When I key up on either PL, the audio goes out the link.
Can anyone verify this? Are there any other config changes that need to be made?
Thanks
···
Sincerely,
boB - W5EVH