CLI command gone

AllStarLink
1

There used to be a CLI command that I found very useful that is gone now with this ASL3 stuff. Is there anything like it? I went thru all the commands and didn't fins anything like it.
It was rpt showvars

Not only did it show RX and TX conditions but gave a list of all connected nodes. I used it a lot and is one of the reasons I keep several repeaters on pre-ASL3.

Bottom line would be a way to see connected nodes

GeorgeC W2DB

2

Are you looking for : rpt show variables <nodename>

3

Tried that on an ASL3 node and it works. Just puzzled by why it was changed.

Thanks

GeorgeC

4

That was one of the many changes made when moving ASL3 from the old version of asterisk to the current/modern code base.