; If you are going to use this channel driver, you MUST enable it in modules.conf
; change:
; noload => chan_echolink.so 		; echolink Channel Driver
; to:
; load => chan_echolink 			; echolink Channel Driver

[el0]
call = N3DMC-L						; Change this!
pwd = *********						; Change this!
name = Dave McClure					; Change this!
qth = Riesel, TX						; Change this!
email = dave@n3dmc.org						; Change this!
node = 265441                       ; Change this!
; Data for EchoLink Status Page
lat = 31.522048							; Latitude in decimal degrees
lon = -96.951784							; Longitude in decimal degrees
freq = 0                          ; not mandatory Frequency in MHz
tone = 0                          ; not mandatory CTCSS Tone (0 for none)
power = 0							; 0=0W, 1=1W, 2=4W, 3=9W, 4=16W, 5=25W, 6=36W, 7=49W, 8=64W, 9=81W (Power in Watts)
height = 0							; 0=10 1=20 2=40 3=80 4=160 5=320 6=640 7=1280 8=2560 9=5120 (AMSL in Feet)
gain = 0							; Gain in db (0-9)
dir = 0								; 0=omni 1=45deg 2=90deg 3=135deg 4=180deg 5=225deg 6=270deg 7=315deg 8=360deg (Direction)

maxstns = 20						; Max Stations

rtcptimeout = 15					; Max number of missed heartbeats from EL
recfile = /tmp/echolink_recorded.gsm	;
astnode = 503602						; Change this!
context = radio-secure				; Default in code is echolink-in

; Max 4 servers
server1 = nasouth.echolink.org
server2 = naeast.echolink.org
server3 = servers.echolink.org
server4 = backup.echolink.org

; To deny w6xxx you would add the statement: deny = w6xxx
; To prohibit computer-based connections you would write: permit = *-*
; To allow access to only a select group of callsigns: permit = w6abc,w6def,...

; permit							; comma delimited list of callsign, type (-r)
; deny


; Remote text commands thru netcat:
; o.conip <IPaddress>    (request a connect)
; o.dconip <IPaddress>   (request a disconnect)
; o.rec                  (turn on/off recording)

; ipaddr
; port

#tryinclude custom/echolink.conf