So, there is a “speed=” in the morse stanza. Does it have a governor on it to limit the speed maximum to 20 wpm? My entries greater than 20 make no difference. And why would I want faster than 20 wpm you ask, my HUB nodes are only send “ID” to web transceivers, and I would like them faster. I have observed that at 20 wpm, there is a bit of jitter and faster may not be possible. (An ID I built years ago had a limit on how fast it could go before the code elements were overrun by timing)
I’ve been meaning to ask that same question.
Rules wise, since there’s no CW requirement at all for ‘any’ license, then there shouldn’t be a speed limit on how fast repeater id’s should be limited to.
I like my code speed around 30~35wpm these days. I used to copy NTS traffic at 40+wpm. 20wpm is such a ‘~yawn~’ bore…
Tim's not being heavy-handed. Just guiding us back to the conversation regarding app_rpt.
That being said, does anyone know if there a command to toggle all telemetry off altogether, plumb?
No Allison, no courtesy tones, no tail-messages, no -nothing- (save ID) and (bonus) no hangtime?
My UHF repeater is a Motorola R-100 (backyard repeater) with DCS tone access. I'm trying to get the tail as short as possible. Wait-times have been set to 0, as well as hangtime, but there's still a 'tail'...
-Geoff/W5OMR
···
On 12/17/2013 08:46 AM, Jim W7RY wrote:
Usually when a moderator gets heavy-handed.... Conversations stop for a while.
Usually when a moderator gets heavy-handed… Conversations stop for
a while.
Tim’s not being heavy-handed. Just guiding us back to the conversation
regarding app_rpt.
That being said, does anyone know if there a command to toggle all
telemetry off altogether, plumb?
No Allison, no courtesy tones, no tail-messages, no -nothing- (save ID)
and (bonus) no hangtime?
My UHF repeater is a Motorola R-100 (backyard repeater) with DCS tone
access. I’m trying to get the tail as short as possible. Wait-times
have been set to 0, as well as hangtime, but there’s still a ‘tail’…
Usually when a moderator gets heavy-handed… Conversations stop for
a while.
Tim’s not being heavy-handed. Just guiding us back to the conversation
regarding app_rpt.
That being said, does anyone know if there a command to toggle all
telemetry off altogether, plumb?
No Allison, no courtesy tones, no tail-messages, no -nothing- (save ID)
and (bonus) no hangtime?
My UHF repeater is a Motorola R-100 (backyard repeater) with DCS tone
access. I’m trying to get the tail as short as possible. Wait-times
have been set to 0, as well as hangtime, but there’s still a ‘tail’…
