# Questions about installing and using VOIP phone with Allstar **URL:** \ **Category:** AllStarLink\ **Created:** [November 21, 2020, 4:11am UTC](https://community.allstarlink.org/t/questions-about-installing-and-using-voip-phone-with-allstar/17850 "2020-11-21T04:11:02Z")\ **Posts on this page:** 1\ **Showing post:** 8
**Author:** ![kf5dey](https://community.allstarlink.org/letter_avatar_proxy/v4/letter/k/3ec8ea/32.png) [@kf5dey](https://community.allstarlink.org/u/kf5dey)\ **Post date:** [November 23, 2020, 5:24am UTC](https://community.allstarlink.org/t/questions-about-installing-and-using-voip-phone-with-allstar/17850/8 "2020-11-23T05:24:09Z")
What you are saying makes sense, after narrowing down the edits to the two files sip.conf and extensions.conf I got a working system… However it isn’t working 100%. No Node ID info is being sent or read and at best it is very annoying…since it announces N-O-C-I-D… I attempted about 10 different solutions for the NO-CID node… including this attached one…but nothing changes. Again, the setup is I am using my primary node number in all instances as required, and I am not running a PBX or Asterisk server outside the Allstar install. Mike > [@SIP -Cisco303 & No Caller ID](https://community.allstarlink.org/t/sip-cisco303-no-caller-id/15198): > > Allstar Team, Hello, I want to be able and display my call or similar node info in allmon or supermon, notice the screen shot below highlighted in yellow. It says " NO-CID" I’m using a Cisco 303 to dial into my node, admins from reflectors and networks are asking me all the time to get this fixed because it does not identify me or my node. [image] Here is my SIP.conf info : [lineone] type=friend host=dynamic username=500540 secret=passwordone dtmfmode=rfc2833 mailbox=500540 ; Mailbox f… --- _[View the full topic](https://community.allstarlink.org/t/questions-about-installing-and-using-voip-phone-with-allstar/17850)._