# Main Hub Server Share Autopatch With IAX Connected Private Nodes?

**URL:** <https://community.allstarlink.org/t/main-hub-server-share-autopatch-with-iax-connected-private-nodes/17559>\
**Category:** AllStarLink\
**Created:** [September 16, 2020, 12:30am UTC](https://community.allstarlink.org/t/main-hub-server-share-autopatch-with-iax-connected-private-nodes/17559 "2020-09-16T00:30:07Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![K6IAN](https://community.allstarlink.org/user_avatar/community.allstarlink.org/k6ian/32/1471_2.png) [@K6IAN](https://community.allstarlink.org/u/K6IAN)\
**Post date:** [September 16, 2020, 12:30am UTC](https://community.allstarlink.org/t/main-hub-server-share-autopatch-with-iax-connected-private-nodes/17559/1 "2020-09-16T00:30:07Z")

</div>

Good Evening,

In my learning about how to properly change settings and configure a Hub, I have a question…  
Can private nodes on remote sub-servers, that are permanently linked back to the Hub Server that is sharing Echolink with a single Allstar public node number, access the Autopatch that is enabled on the Hub? Or does running those sub-servers block the dtmf command to pull up the Autopatch on the Hub? I don’t have any RTCM’s at the moment, but I would imagine they wouldn’t have a problem calling up the Autopatch on the Hub.

I know Autopatch is kinda considered taboo and outdated, but if I figured the system I am swapping out had Autopatch, I might as well enable it on this one.

Thanks for any suggestions or guidance. I have been scouring the forums and wiki pages looking for info.

Ian

---

<div class="post-metadata">

**Author:** ![K6IAN](https://community.allstarlink.org/user_avatar/community.allstarlink.org/k6ian/32/1471_2.png) [@K6IAN](https://community.allstarlink.org/u/K6IAN)\
**Post date:** [September 16, 2020, 2:18am UTC](https://community.allstarlink.org/t/main-hub-server-share-autopatch-with-iax-connected-private-nodes/17559/2 "2020-09-16T02:18:20Z")

</div>

I stumbled onto this in the Allmon thread group… Does this still work, as I don’t see this anywhere in my fresh install on Debian in my rpt.conf file.

[rpt.conf]  
#Command Mode  
remote\_dtmf\_allowed=1

at repeater with DTMF  
\*4 nodenumber to enter command mode

---

<div class="post-metadata">

**Author:** ![WD6AWP](https://community.allstarlink.org/user_avatar/community.allstarlink.org/wd6awp/32/5_2.png) [@WD6AWP](https://community.allstarlink.org/u/WD6AWP)\
**Post date:** [September 16, 2020, 2:28pm UTC](https://community.allstarlink.org/t/main-hub-server-share-autopatch-with-iax-connected-private-nodes/17559/3 "2020-09-16T14:28:04Z")

</div>

I believe remote\_dtmf\_allowed=1 is the default. I was going to look at the wiki to see if it’s documented but it’s down this morning. Will check later.