Hi Steve,
I’ve seen the document you shared. Unfortunately, this does not really apply to my situation as I am using the GPIO inputs/outputs directly off of the CM chip via the RepeaterBuilder USB-RIM interface. What I have done is taken all of the signals to/from the MTR2000 via it’s “System Connector” on the backplane and are carrying them to the USB-RIM interface via a single 25-Pin connector. I know how to identify the GPIO pins as inputs vs outputs in the usbradio.conf file. It’s the programing of the alarm actions in rpt.conf that I am confused by.
Hope that helps,
Tom