Robert,
I’m not sure if this has been overcome so this is a caution.
Perhaps someone in the know will chime in. The ASL version was not able
to run on the Pi4 so if someone doesn’t chime and tell us differently
you will need to run the Hamvoip version if you must install on a Pi4.
If you have a Pi3 you should be okay.
I know Pi4 for ASL issue was being worked on by the members here but I
personally haven;t seen where the ASL version is ready for the Pi4.
Hopefully I’m wrong but wanted to make you aware so you don’t have
unexpected issues.
Larry - N7FM
···
On 1/2/21 12:46 PM, Robert Stroud via AllStarLink Discussion Groups wrote:
[KD5BS] KD5BS https://community.allstarlink.org/u/kd5bs
January 2I am considering using AllStar to link two Club repeaters together. I
have read pretty much all of the Wiki information regarding the Software
setup and installation so am prepared for that effort.
What is unclear to me is the actual hardware and connection
requirements. Let me explain a bit…
We have two Yaesu DR-2X repeaters that are about 10 miles apart - one is
a 2 meter machine and the other is a 440 machine. Both have Internet
available.
I am prepared to build AllStar nodes (which are already registered) on
Raspberry Pi 4 SBCs. I haven’t run across any documentation the details
the actual hardware requirements Is there a document that describes and
shows a schematic of how to put together a connection to a repeater
including any RPi Hats, Interface devices, cables etc. If someone has
undertaken this project with a Yaesu DR02X repeater, I would very much
appreciate your guidance and input on how to proceed.
;I might also mention that we want to implement a DVSwitch capability to
bridge DMR to Analog for these repeaters as well so any details about
this implementation would also be appreciated. For example, 1) should
the DVSwitch be installed on a separate RPi?, 2) if repeaters are in
separate locations is it necessary to have a separate RPi at each
repeater or can one RPi support both repeaters and if so, how?
I realize that this is basic stuff for many of you and believe me, I
would not be asking this if I had found information that describes my
particular scenario.
If anyone can provide some assistance and Elmering on this project, I
would appreciate it.
Thanks
Visit Topic
https://community.allstarlink.org/t/get-started-with-allstar-hardware-requirements/18015/1
or reply to this email to respond.You are receiving this because you enabled mailing list mode.
To unsubscribe from these emails, click here
https://community.allstarlink.org/email/unsubscribe/acb8d2633d9db9c9642cfaf642a6c297980efbcc9d92cad92cc7658b0838322f.