Go to hamvoip.org there is how to set up node This is where I went to setup my 2nd Bf-888s.when 1st 888s stopped working and when a guy brought me his yellow box node to see if I could get it to work, he is blind and had the node about a year till finally bringing it to me, used same site to get node working.
···
On Mon, Nov 23, 2020 at 10:49 PM Steve via AllStarLink Discussion Groups <noreply@community.allstarlink.org> wrote:
| kb7kwk
November 24 |
- | - |
I new to Allstarlink and pretty much Linux as well. I am trying to get my node set up and followed the instructions on the site however, when you get to this point I am stuck. AllStarLink Audio settings with SimpleUSB
type sudo asl-menu like the example bellow:
repeater@repeater:~$ sudo asl-menu
Choose option <4>.
101 asl menu 4.pngWith option , will triger PTT few times on your radio for testing, you should also listen a test tone.
I go to option 4 and it goes to another screen saying you have to enable simpleusb in modules.conf and enable it in rtp.conf. I finally found out how to get to the files but have no idea how to select, or enable them. There is almost nothing on how to do this online. I take it back, there is nothing online. I have been searching for two days. Can anyone help a newbie figure this out? Is there somewhere that has complete instructions on how to setup a node?
Visit Topic or reply to this email to respond.
You are receiving this because you enabled mailing list mode.
To unsubscribe from these emails, click here.