# ASL3 link commands

**URL:** <https://community.allstarlink.org/t/asl3-link-commands/22525>\
**Category:** Archive\
**Tags:** asl3\
**Created:** [December 22, 2024, 10:12pm UTC](https://community.allstarlink.org/t/asl3-link-commands/22525 "2024-12-22T22:12:27Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![k5map](https://community.allstarlink.org/letter_avatar_proxy/v4/letter/k/6bbea6/32.png) [@k5map](https://community.allstarlink.org/u/k5map)\
**Post date:** [December 22, 2024, 10:12pm UTC](https://community.allstarlink.org/t/asl3-link-commands/22525/1 "2024-12-22T22:12:27Z")

</div>

I have a fresh built ASL3 node. In the rpt.conf file it has comments about \*13 doing a permanent connection and \*11 disconnecting a permanent connection. So, I added these lines to my rpt.conf file:

- 11 = ilink,11
- 13 = ilink,13

After restarting asterisk, if I run either of the commands below, nothing happens on my node. Is there another change to rpt.conf I need to make for them to work?

asterisk -rx "rpt fun \<node#\> \*13  
asterisk -rx "rpt fun \<node#\> \*11

---

<div class="post-metadata">

**Author:** ![N8EI](https://community.allstarlink.org/user_avatar/community.allstarlink.org/n8ei/32/4254_2.png) [@N8EI](https://community.allstarlink.org/u/N8EI)\
**Post date:** [December 23, 2024, 2:56pm UTC](https://community.allstarlink.org/t/asl3-link-commands/22525/2 "2024-12-23T14:56:06Z")

</div>

If you left `*1` defined then `*11` and `*13` will always be translated as `*1` and the next number being the input to that.

---

<div class="post-metadata">

**Author:** ![k5map](https://community.allstarlink.org/letter_avatar_proxy/v4/letter/k/6bbea6/32.png) [@k5map](https://community.allstarlink.org/u/k5map)\
**Post date:** [December 23, 2024, 4:08pm UTC](https://community.allstarlink.org/t/asl3-link-commands/22525/3 "2024-12-23T16:08:17Z")

</div>

Ah ok that makes sense… when I was updating the rpt.conf file to remove the 2 lines I added, I noticed there were \*811 and \*813 commented which have the same ilink command. So I’ll use them.

---

<div class="post-metadata">

**Author:** ![system](https://community.allstarlink.org/uploads/default/original/2X/4/42700284e201b031bd667c3f63bbae05a74b3104.png) [@system](https://community.allstarlink.org/u/system)\
**Post date:** [December 26, 2024, 4:08pm UTC](https://community.allstarlink.org/t/asl3-link-commands/22525/4 "2024-12-26T16:08:53Z")

</div>

This topic was automatically closed 3 days after the last reply. New replies are no longer allowed.